Radar from MASH

Why can’t they use the excess energy to make the train go again?

Is there a bad taxidermy community?

They were asking for a ride. She speaks Ukrainian. I’m guessing she wasn’t bothered by it.

I might have crossed my wires, it was probably just a forum post I misread. I happened to have new ceramic burrs so I went ahead and installed them.

I got closer to a perfect pull this morning after adjusting the right lever! Unfortunately I’m out of that coffee now so the process restarts with the next bag.

New ceramic burrs.

I typically use light roast beans, apparently ceramic is better there.

Went through the hyperalignment procedure and got close but not perfect. Had to move on and get it back together at some point.

Works the same, just inline. And this grinder has two

I don’t know about best, but these have been decent

Slurping Turtle (Easton)

Wild Ginger (Hilliard)

Aki Hana (Henderson)

Me writing my resume in third person

Me, spending hours on Age of Empires 2 and loving it

True with crimps, not as important with pinches, which is what this mug is

This is how I did it with my old board. My new board has a jumper to toggle between powering via USB and not.

When the only tool you have is a deep lifelong understanding of computational language, everything starts to look like a hypergraph.

Cisco Webex.

You think teams or zoom are annoying? This is much worse. The worst part is with some default meeting settings, a loud chime would play every time someone joined. People kept this on for meetings of 300+ people, then they started talking over the beeps once “the popcorn slowed down.”

Extraction is heavily controlled by amount of water, temperature, grind size, and time.

To get an under extracted brew, you would use more water with a shorter brew time with a course grind at a lower temperature. This should give you something that’s sour, weak, watery, with a thin mouthfeel.

Overextraction would be the opposite. Boiling water in a preheated brewing device, fine grind, less water, steeped for a longer time. This should taste dark, bitter, burnt, strong, with a soupy grimy mouthfeel.

You can make one cup of each at the extremes to taste the difference, and then use that information to tweak your regular brew one variable at a time. Look up the coffee compass to help understand what you’re tasting and which direction to move.

As opposed to Cole’s law, which is a finely shredded cabbage salad

It’s a joke about software development tools breaking in dumb ways, and that it’s not a problem with saws

I’m a software engineer who does woodworking, and I approve this message.

But my favorite explanation: you grab your hand saw, and it works. You don’t find out that the latest npm japanese-hand-saw-tooth package is incompatible with plywood, and you need to downgrade the package or buy new plywood to make a cut.

This should be a Will Ferrell movie

If you happen to live in a city that has one, check out this online showroom: https://sandmansleep.net/

I tried all of the mattresses, and was surprised with what I found. The Latex ones weren’t as comfortable for me as hybrid foam/coils. On a lot of beds, I could feel the lower firmer layers on my hips laying on my side. Latex felt so springy it was almost trying to roll me off the bed.

I guess my advice is to try in person however you can. I spent some time looking at naplab, but the scores range from 9.5 to 9.8 so they mattresses aren’t even differentiated. In person, there were big differences that weren’t captured in the scores, which try to be subjective but miss a lot.