This article seems either written or assisted by Ai. It flows really weirdly.
I’ve had my eyes on this one for a while. My daily driver is their Navigator frame. I’ve been planning on converting it to an Ebike using a 750watt motor kit.
This is basically my assessment too. Good write up :)
Thank you so much. As a Relay fan, I’ve been looking for something to fill that space. And lift off wasn’t quite doing it for me.
I have a Psion 5mx and there’s a Debian port for it which is crazy. I’ve been on the fence about installing it for similar reasons.
I’m with you 100% if push comes to shove I’m selling everything else before selling my tools. Unfortunately. My tools are where a lot of my money is lol.
I’m with you 100% if push comes to shove I’m selling everything else before selling my tools. Unfortunately. My tools are where a lot of my money is lol.
I’ve always wanted to go the fairphone route but have been worried about the whole ecosyatem discontinuing and I’d be left without good replacements.
I’m with you 100% if push comes to shove I’m selling everything else before selling my tools. Unfortunately. My tools are where a lot of my money is lol.
Direction specific force loading. In this particular instance, Having it run the infill along the perimeter of the part would improve it.
Yellow is perimeter lines, the goal is to not use infill at all, and to just use multiple perimeter passes.
They dramatically increase print times and increase blemishes. It’s such a small surface area, that it just ends up creating blobs and shakes the printer.
Trying to find a good relay replacement myself. Maybe one day the Dev could make a relay for lemmy, one can dream.
This was a plot in Repo! The Gentic Opera.