I know two ways.

The first one is to measure the non-linear flow of the filaments. Check this : https://wiki.bambulab.com/en/software/bambu-studio/calibration_pa

The other one is to measure vibrations responses to avoid some frequencies. It removes ghosting.

What printer are you using?
New printers like the Bambulabs, or Creality K1 are compensating lots of issues now, and you can print nearly perfect prints.

Operation destapler

These aluminim spoons are nice !

I have bought an AMS, but not to print multiple colours. It’s to load and unload the filament for me. It’s really great and I would not want to go back.

I have read about cricut like capabilities. It looks interesting but prone to catastrophic failure.

50-50 is about ending the war or reclaiming lost territories.

Polls about US support in your link is : “Americans are also split as to whether the U.S. is doing too much (37%), the right amount (31%) or not enough (30%) to aid Ukraine.”

So 37% : “we should do less/abandon/be against Ukraine”
and 62% : “we should continue to back up Ukraine”