• MickiusMousius@lemmy.world
    link
    fedilink
    English
    arrow-up
    3
    ·
    1 year ago

    This is awesome, I have a similar design coming from JLPCB this week (it is a bit more Corne like though).

    Any advice or important lessons you learned?

    • dnl@lemmy.worldOP
      link
      fedilink
      arrow-up
      5
      ·
      edit-2
      1 year ago

      The main lesson I learned was probably to start thinking “in hardware” and not software. Like you design something and it fits on paper but in reality, it might not be ideal. For example, my diode placement is very close to the hotswapsocket (i fixed that for rev 1.1). On paper it war fitting, but its kinda hard to solder when you need room for your solder iron in between - this is something kicad won’t tell you.

      • MickiusMousius@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        edit-2
        1 year ago

        Thanks. I must admit I am curious to see what mistakes I’ve made this coming weekend. My first KiCAD PCBs should arrive this week, then the penny shall drop I suspect.

        If you’ve not tried it yet I’d recommend having a go at reflow soldering with a hot plate. It makes some aspects of assembly easier.

        I haven’t yet had a chance to get two rotary encoders working under ZMK yet either. Did you have a good resource to use for that or did you need to figure it out yourself?

        (Appreciate I’m asking a lot of questions sorry).

        EDIT: I see you’ve posted your ZMK config, nice 😊

        • dnl@lemmy.worldOP
          link
          fedilink
          arrow-up
          2
          ·
          edit-2
          1 year ago

          There is a zmk pull request open that adds split encoder support. If you use that to build your firmware if should work.

          To be honest I have not tried it with this board so technically one scrollwheel is not working right now. Though I’ll change that soon. I used a fork that supports split encoder with zmk on my sofle and it worked, so you could use this config for some inspiration (here: https://github.com/dnlbauer/sofle-zmk-config).

          • MickiusMousius@lemmy.world
            link
            fedilink
            English
            arrow-up
            2
            ·
            1 year ago

            Awesome, thank you.

            I have a Sofle to test with ahead of assembly. Also “my design” is based on the Sofle (electrically at least), this is super helpful!