So my Sofirn SP10 Pro was freaking out today. I don’t think it was some weird mode I got into but whatever it was, I couldn’t get out of that messed up state. As I was going to bed I realized and Anduril is awesome and there must be some reset procedure. Looked it up and had my flashlight working again and back in advanced UI in under a minute.
I really appreciate ToyKeeper and the awesome programming she has done.
I don’t know about fan control but Anduril does support RGB aux lights. Here is the Anduril manual showing how to change RGB colors of the aux led.
Yeah but anduril only has low and high for every colour while i want gradual(prolly 8 bits) control of all three channels(rgb)
I believe that with the aux lights, it’s a hardware limitation.
The TiTS10 has the new multi-channel Anduril that allows you to enable each color of aux as a channel; try 9H from On and keep holding. However, it only has them on High with 1H/2H doing nothing. You can 3C between them and normal operation (Channel 1; main emitters), but that’s it.
Yeah the chips dont have enough I/O. I couldnt find any vidoes showing the aux of the TS10. I could maybe have another chip store the values of rgb so you can set them with 1H for each colour and then go back to normal operation.
Fair enough. Seems like it could be programmed in but I don’t know if it requires more memory or processing than is standard for flashlight controllers. But if it’s a custom light, then you can design your control board to have more umpf and use a customized firmware.
Yeah the chips that anduril works on dont have enough I/O