Hi, I’m new to printing. I got myself a Kobra 2 and it was printing fine when I got it. But recently it started to knock the prints off at random times. I have done several recalibrations, adjusted the Z offset up and down. What I have noticed is that all of these models seem to have a small overflow of material which I’m guessing the nozzle is bumping into. But I have no idea what causes it. I’ll post the latest print that failed, there the extra material is more pronounced than usual. Any suggestions what I should adjust? (Btw I’m using Octoprint)

  • feecoomeeq@lemmy.world
    link
    fedilink
    arrow-up
    1
    ·
    1 year ago

    In my cade it was eSteps calibration and flow cube print calibration. After setting this up (flow 91%), issueless prints