Truck gets power and attempts to turn over.

Which made me think it wasn’t the starter or battery.

Looking things up online it pointed me to the fuel pump.

I went through and did the whole diagnostics with checking that. Including checking the fuses and relay.

I found a video saying the fuel pump control module could be messed up, and it looked pretty rusted out so I changed that. But it didn’t fix the issue.

So I going back to the fuel pump diagnostics of the fuel pump, it said to turn the accessory on with the key and you should hear the fuel pump kick on if you put your ear to the gas cap. I did but I honestly don’t know what I’m supposed to be hearing.

I’ll probably go ahead and replace it, but is there anything else that I should be checking or what?

  • Varyk@sh.itjust.works
    link
    fedilink
    arrow-up
    1
    ·
    2 months ago

    got it.

    ignition coils spring to mind in that case also, and you have to remove them to get to the spark plugs anyway on the f150

    a bad ignition coil could cause the non-sparking issue.

    spark plugs, ignition coils, starter solenoid, then starter motor is the order I’d go.

    If you’re going to replace all the plugs anyway and you have the cash, replacing each ignition coil as you go rather than popping the old ones back in isn’t going to hurt, especially if the truck’s near 100k miles.

    spark plugs are more likely to fail and fail sooner, so if you want to try switching them out first, also no harm there.

    it’ll end up being whichever is at the bottom of your checklist, of course, but the sudden failure has me leaning toward a single electrical point of failure rather than fuel delivery.

    • Cheems@lemmy.worldOP
      link
      fedilink
      arrow-up
      2
      ·
      2 months ago

      I think at this time I’ll swap out the sparks. Just as I’ve already done so much. Coils will be on my list though.

    • Cheems@lemmy.worldOP
      link
      fedilink
      arrow-up
      2
      ·
      2 months ago

      I had tried everything I could think of and ended up taking it to a shop.

      They ended up fixing it in a day.

      The issue? The grounding wire was corroded.

      • Varyk@sh.itjust.works
        link
        fedilink
        arrow-up
        2
        ·
        2 months ago

        whoa!

        congratulations, I’m glad it’s working again.

        thanks for letting me know, now I’m watching F-150 videos about corroded grounding wires.

        not an uncommon problem, apparently.