So, I joined the world of waxed chains. So far, it’s life changing. Quiet to the point that your think I’m running a belt drive, but more importantly, super clean and component preserving.
But, I was thinking earlier, if wax fills in the gaps between the parts the wear, how would you actually get a true chain wear measurement?
I’ve never heard of someone stripping the wax off to check for wear, and that would get incredibility wasteful to do it often.
Zero friction Cycling doesnt mention anything special in regards to checking a waxed chain.
So, would I go about checking the chain, waxed and all, and assume the numbers are pin point accurate?
I was under the impression that all pins in the series add up to the measured wear, like in this image:
That’s exactly correct. The point that the wax could interfere with the measurement is only where the chain checker touches the chain. Waxed chains wear much slower than usual, though, so I wouldn’t be too worried about it.